New Printer Standoffs and a Rebuild

================================================================================

There are lots of mods and additions for the Anycubic Kossel on Thingiverse
(https://www.thingiverse.com/search?q=anycubic+kossel). I’ve been looking to
reduce the footprint of my 3D printer for a while now as it currently shares the
same desk as my PC. I came across a set of standoff legs and immediately
downloaded and printed them.

They printed great, with no failures and no adhesion problems. One of the legs
even has a mount for the PSU power cable.

I had to take apart the entire base of the printer to install the 3D printed
T-nuts that attach the standoffs to the bottom of the printer with M3 screws,
and redo the wiring so that I could position the PSU under the printer, but it
was completely worth it.

The printer seemed like it’s finally dialed in… and then I had to go and
dismantle it to install the standoffs. Ah well!

Kossel 2020 Riser Feet: https://www.thingiverse.com/thing:2460490 T-nut M3 2020
aluprofile: https://www.thingiverse.com/thing:1073567

[IMAGE: https://blog.omgmog.net/images/3d-printing/IMG_20180321_155547.jpg]

[IMAGE: https://blog.omgmog.net/images/3d-printing/IMG_20180321_155555.jpg]

[IMAGE: https://blog.omgmog.net/images/3d-printing/IMG_20180321_171852.jpg]

[IMAGE: https://blog.omgmog.net/images/3d-printing/IMG_20180322_145219.jpg]

================================================================================
Published March 21, 2018

Generated from the original post:
https://blog.omgmog.net/post/printer-mods-2/


Max Glenister is an interface designer and senior full-stack developer from
Oxfordshire. He writes mostly about front-end development and technology.

- Mastodon: https://indieweb.social/@omgmog
- Github: https://github.com/omgmog
- Reddit: https://reddit.com/u/omgmog
- Discord: https://discordapp.com/users/omgmog#6206